Hot Racing aluminum wide axle kit for the Tamiya Clod Buster vehicles (Clod, Super Clod, or Bullhead)
FEATURES:
- 15mm widen track on each side (total 30mm) - Bushing support kingpins for super smooth steering action - Smaller c-hub make it for possible 2.2 in wheel - CNC 6061-T6 Aluminum construction, silver in color - These tubes will increase the drive shaft strength of your Clod rock crawler - This kit requires a linked suspension and is NOT compatible with the factory radius arm (ladder bar) suspension
YOU WILL RECEIVE:
- Two (2) aluminum extended axle tubes - Two (2) hardened steel drive shafts - Two (2) aluminum bevel joint side gear couplers - Four (4) brass bushings - Four (4) 5x8mm nylon steering bushings - Two (2) aluminum link mounts - Four (4) 4x12mmscrews
REQUIREMENTS:
- These tubes will ONLY work with the Hot-Racing CB2108 Clod Buster steering knuckles! - One order completes one axle. Order sets to complete one model. - This kit requires a linked suspension and is NOT compatible with the factory radius arm (ladder bar) suspension
SPECIFICATIONS:
- Approximate total length: 93mm (3.7 inch) - Gearbox flange diameter: 29.5mm (1.16 inch)
COMMENTS:
- Replaces Tamiya E1 axle tubes, BS4 drive shaft, and BS5 drive shaft - 5x8mm bearing can be use in place of the bushing - Replacement/spare drive axle shafts are Hot Racing SCB20EL - Replacement/spare hardware kit is Hot Racing RCB20EL08 SN April 15, 2015
FEATURES:
- 15mm widen track on each side (total 30mm) - Bushing support kingpins for super smooth steering action - Smaller c-hub make it for possible 2.2 in wheel - CNC 6061-T6 Aluminum construction, silver in color - These tubes will increase the drive shaft strength of your Clod rock crawler - This kit requires a linked suspension and is NOT compatible with the factory radius arm (ladder bar) suspension
YOU WILL RECEIVE:
- Two (2) aluminum extended axle tubes - Two (2) hardened steel drive shafts - Two (2) aluminum bevel joint side gear couplers - Four (4) brass bushings - Four (4) 5x8mm nylon steering bushings - Two (2) aluminum link mounts - Four (4) 4x12mmscrews
REQUIREMENTS:
- These tubes will ONLY work with the Hot-Racing CB2108 Clod Buster steering knuckles! - One order completes one axle. Order sets to complete one model. - This kit requires a linked suspension and is NOT compatible with the factory radius arm (ladder bar) suspension
SPECIFICATIONS:
- Approximate total length: 93mm (3.7 inch) - Gearbox flange diameter: 29.5mm (1.16 inch)
COMMENTS:
- Replaces Tamiya E1 axle tubes, BS4 drive shaft, and BS5 drive shaft - 5x8mm bearing can be use in place of the bushing - Replacement/spare drive axle shafts are Hot Racing SCB20EL - Replacement/spare hardware kit is Hot Racing RCB20EL08 SN April 15, 2015
